In this guide you use Tor version 0.3.1.9. Great write-up! This guide is a bit old, so just a few comments for those reading this guide later on. OK that was the installation of Tor but we will not start the service. So hit enter and do something else because it takes time)

If you haven't install the above packages or openssl you will see an error message and the building will stop after a couple of minutes. (This is the last but long step, if you done the previous commands correct the building will last about 35 minutes using the wifi of your Rasperry pi,that's how it took my Raspberry Pi 3. #Enter the folder you just unzipped with the command cd tor-0.3.1.9 #Unzip the image you just downloaded with the command tar xzf tor-0.3.1.9.tar.gz Wget wait a couple of seconds until the file is downloaded. OK we have installed the additional packages and we will download Tor. #Install zlib-> sudo apt-get install zlib1g-dev #Install libevent -> sudo apt-get install libevent-dev #Install libevent-dev -> sudo apt-get install libssl-dev Open a terminal and start typing the commands: Openssl - your OS is updated so you don't need to do nothing, Just install libssl-dev.In order to use Tor we also need to have installed: It takes time and we will work from the terminal. In this step we will install Tor from source.

Tor browser linux raspberry pi